Question: If I use the ARP 5/16 bolts, will that be sufficient on my build. If you are running an application beyond this, It is recommended you install 7/16 rocker studs and guide plates. of open pressure before the 5/16 bolt will fail. "This rocker system is capable of handling 350lbs. They also have a side note regarding 5/16 studs: I couldn't find a 1.7 Pedestal Rocker on the Harland Sharp site, they do make a 1.6 SBF. However, when everything is correct it is possible to use open pressures as high as 350 lbs.spring load." I couldn't find any installation instructions on Scorpions page regarding the Pedestal Rocker, but they did make a comment: They look like quality rockers and a lot cheaper than Yella Terra. This is my first Cleveland build, so if something doesn’t seem right let me know.Ī forum member suggested to use the Scorpion pedestal rockers. What are my choices for a Roller Pedestal Rocker?
The Block is a 1970 DOAE-J, w/ new 0.30 Flattop 4cc Pistons, Stock bottom end with ARP hardware The build will be for cruising and maybe some street racing (the least of the 2). I’m now thinking that the Crane Kit could be a weak link. This would allow the use of 7/16 studs and the Magnum Rockers. Yella Terra is too much and I thought that the Comp Magnum Roller Rockers – (1411-1) with Crane Kit (p/n: 52655-16) would be good. I’m looking for a set of Pedestal Rockers besides the stock ones that I have and something that won’t break the bank.
0 kommentar(er)
